![]() REMOVE BATTERY Note: The distance may vary according to the brightness of ambient light. seek + buttons In DVD mode, Press button to skip to the next track. 23.SEL button Press it to enter the SOUND SETTING menu, and press Cursor UP/DN buttons to choose an item and press cursor left/right buttons to set the item. Press it and hold for two seconds in DVD mode to zoom the image in or out in the sequence of ZOOM 2-> ZOOM 3-> ZOOM 4-> ZOOM 1/2-> ZOOM 1/3-> ZOOM 1/4. In BLUETOOTH mode, press it to make a # symbol. AS (Auto Save): Long press to save the stations with good reception automatically. In Radio mode: PS (Preset Scan): Press to scan all preset stations in the memory of the current band and stay on each memory stations for about 5 seconds. P.SCN/ RPT /# In SD CARD/ USB mode, press to repeat REP 1 => REP DIR => REP ALL In DVD mode, press to start repeat REP OFF=>REP Chapter=>REP Title=>REP Off. REMOTE CONTROL 1: 2: 3: 4: 5: 6: 7: 8: 9: MODE POWER BAND/RANDOM/Clear ENTER UP/DOWN/LEFT/RIGHT EJECT STEREO/MONO/* P.Ĩ. * Supported Music File Format: MP3, WMA Files. ![]() Insert a SD/MMC CARD into this slot and the unit will automatically start reading and playback the card. SD/MMC CARD slot SD/MMC card slot, for Multimedia playback files only. In Bluetooth mode, press to make a call after inputted a phone number or accept an incoming call. Press button and hold for two seconds to activate fast reverse (REW) search in a track. In DVD / SD / USB mode, press button to skip to the previous track. Button/ Button In RADIO mode, press to start automatic searching, press and hold for two seconds to start manual searching, then press to tune each frequency step downward. SEL/MUTE Button SEL : Long press it to enter SOUND SETTING menu to adjust the sound settings EQ => BASS => TREBLE = > BALANCE => FADER => EQ.Ĥ. To attach it, insert the right side first and then press the left side until hear a click sound. ![]() Detach/Attach the Panel: Press REL button and pull out the left side to detach the panel. When the unit was released, it will switch off automatically after a few second. Release Button Press to detach and release the front panel. The unit is using a BTL circuit and each loudspeaker must be connected with insulated cables according the diagram.įront panel 1. Do not use 3-cable loudspeakers and do not connect the loudspeakers minus to the car body (GND). Use 4~8 Ω (Ohm impedance) loudspeakers only using higher or lesser impedance may damage the unit. Use only loudspeakers of minimal 40Watt, using fewer watts may result in damaging your loudspeakers at higher volumes. Note: - Only use groundless loudspeakers. 2 cables is connected to a Hands-Free device (not included). Note: To watch video the parking wire should be connected to break signal. Whenever the unit is disconnected from the battery, the preset memory will be erased and the unit will go back to its factory defaults. WIRING CONNECTIONS NOTE: Never connect cable to the system while it is connected to the battery power. Install the unit where it does not get in the driver’s way and will not injure the passenger in case there is a sudden stop, like an emergency stop. The use of unauthorized parts may cause malfunction. Use only the parts provided with the unit to ensure proper installation. INSTALLATION / UN-INSTALLATION Note Before starting installation of the unit, make sure the wiring is connected properly. (1) Washer, Spring Washer, M5 Nut 1 each (2) Mounting Strap 1 (3) Bolt 5*20 1 (4) Screw 4*6 4 (5) Mounting Collar 1 (6) Release Key 2 (7) Screw 5*20 1 (8) Rubber Cushion 1 1x AV-IN Cable Remote Control Warranty card Power Cable RCA Cable User Manual Trim ring Note: Product image may vary from the actual delivery. Īccessories Package contains the following accessories for installation and operation of the unit. To avoid the risk of damage and injury and the potential violation of applicable laws, this unit is not for use with a video screen that is visible to the driver.ĬONTENTS WARNING!. Improper connection or use of his connection may violate applicable law and may result in serious injury or damage. The Unit is designed to detect parked status and must be connected to the power supply side of the parking brake switch. WARNING! To promote safety, certain functions are disabled unless the parking brake is on. Familiarity with installation and operation procedures will help you obtain the best Performance from your new DVD-receiver. VIR-7830B/ VIR-7830BT In-Dash 7” Monitor Touch Screen DVD/CD/MP3/MP4 AM/FM Radio Built-in TV tuner With Bluetooth Owner’s Manual Take the time to read through this owner’s manual.
0 Comments
Leave a Reply. |